Radon Mitigation in River Heights

River Heights is one of Winnipeg's most established neighbourhoods, built largely between 1910 and 1945 on the clay flats west of the Red River. The original foundations here are a century old in many cases, and while most of these homes have full basements, crawlspaces are extremely common under rear additions, enclosed porches, sunrooms and breakfast nooks added over the decades. Those additions are where we do nearly all our work in the area, and they are frequently founded shallower than the original house.

The classic River Heights crawlspace is small, hard to access through a hatch in a closet or an exterior door, and completely unimproved: a soil or thin slab floor, uninsulated or batt-insulated joists above, and vents that were cut into the wall at some point and may or may not still be open. Because the space sits beside a heated basement but is not itself conditioned, it runs cold in winter and humid in summer. We routinely find frost on the underside of the subfloor in January and condensation and mould on the same surfaces in July.

Mature elms and large lots create a secondary issue: root systems and decades of soil settlement change how water moves toward these foundations, and original clay tile drainage, where it exists, is often collapsed or root-blocked. Our scope here usually involves confirming where surface water goes, sealing and insulating the crawlspace so it joins the conditioned envelope, correcting the insulation strategy at the perimeter rather than the ceiling, and stabilizing any addition framing that has settled relative to the main house.

The typical River Heights call is about a cold back room. A kitchen, breakfast nook or family room added behind the original house sits over a small crawlspace, and the floor is noticeably colder than the rest of the home through winter. Occasionally the call is about a smell that appears when the furnace runs, and occasionally it is a frozen line in that same space. All three trace back to a crawlspace that was never brought inside the heated envelope.

Our first recommendation here is usually perimeter insulation and rim joist air sealing rather than anything dramatic, because that is what resolves the cold floor and the freeze risk together. Access is frequently the practical obstacle — these spaces are often reached through a hatch in a closet — so we assess whether a larger permanent opening is worth cutting while the space is open. On a century-old foundation we also check the masonry condition before sealing anything to it.

Radon is a naturally occurring radioactive gas produced by the decay of uranium in soil and rock. It is colourless and odourless, it moves upward through soil, and it enters buildings through any opening in contact with the ground. Health Canada identifies it as the second leading cause of lung cancer after smoking, and sets a guideline of 200 becquerels per cubic metre for indoor air, recommending remedial action above that level. Manitoba consistently records some of the highest residential readings in Canada, which makes this a local issue rather than an abstract one.

A crawlspace is the most efficient radon entry point a house can have. Where there is exposed soil, or a thin unsealed membrane, soil gas moves into the space essentially unimpeded — and from there into the living area, because the stack effect pulls air upward through a house continuously during the heating season. Our long heating season means that pressure difference operates for a large part of the year. A house with a sealed basement slab but an open crawlspace under an addition can still have substantially elevated levels.

Testing has to come before mitigation, and it has to be done correctly. A long-term test of at least three months, ideally during the heating season when windows are closed and the stack effect is strongest, gives a representative result. Short-term tests are useful as a screening indicator but fluctuate too much to base a decision on. We will arrange or guide testing, and we would rather you test first than buy a mitigation system you may not need — though in a crawlspace with exposed soil, sealing the floor is worthwhile on moisture grounds regardless of the radon number.

Where mitigation is needed, the standard approach in a crawlspace is active sub-membrane depressurization. A sealed membrane is installed across the floor and up the walls — the same membrane used for encapsulation, which is why these two projects belong together — and a dedicated fan draws continuously from beneath it through a perforated collection pipe, venting above the roofline. That negative pressure under the membrane captures soil gas before it can enter the space. The system is simple and highly effective, but it depends entirely on how well the membrane is sealed, which is why installation quality matters more than equipment selection.

Post-mitigation verification is not optional in our view. After the system is running and the building has returned to normal operating conditions, the space and the living area should be retested to confirm the reduction. We also label the system, explain what the manometer reading means, and tell you what to check — because a mitigation fan is a mechanical device that will eventually fail, usually silently. A system nobody monitors is a system that may have stopped protecting you years ago.

Pressure and building dynamics explain why two apparently identical houses can test very differently, and why your neighbour's result tells you nothing about yours. Radon entry depends on the pressure difference between the soil and the building interior, and that depends on stack effect strength, exhaust appliances, mechanical ventilation balance, wind, and how tight the building is. A house with powerful kitchen and bathroom exhaust and no make-up air runs at a greater negative pressure, and draws correspondingly more soil gas. This is also why sealing work and mechanical changes can shift a reading in either direction, and why testing after any significant envelope work is sensible.

System design details separate a mitigation that works from one that merely hums. The collection point beneath the membrane needs a permeable layer — clean gravel or a drainage mat — so the fan can draw from the whole footprint rather than a single spot. The fan has to be sized to the soil's permeability and the area served: too little suction leaves parts of the footprint uncaptured, too much wastes energy and can pull conditioned air if the membrane has gaps. The exhaust must terminate above the roofline and away from windows and air intakes. And the pipe needs a manometer, so the system reports its own status.

Timing relative to encapsulation is the practical advice we give most often. If you are sealing a crawlspace for moisture reasons and you have not tested for radon, test first. The collection pipe and gravel layer belong under the membrane, installed before it goes down; retrofitting them means cutting open a barrier you just paid for and compromising its continuity. A long-term test takes three months, which is usually compatible with planning a project anyway. If the number comes back low, you have lost nothing but gained a documented baseline. If it comes back high, you have saved yourself from doing the job twice.