Radon Mitigation in Île-des-Chênes

Île-des-Chênes sits south of Winnipeg in the RM of Ritchot, on flat, low-lying Red River valley clay. The whole area is shaped by flood management — ring dikes, drains and raised building pads are part of the landscape — and the local water table runs high during spring melt. For crawlspaces that means hydrostatic pressure against walls and floors during the weeks when the ground is still frozen below and saturated above, which is exactly when water finds its way through an unsealed cold joint or a cracked stem wall.

Housing here mixes older rural properties with newer subdivision construction. The older homes often have shallow crawlspaces, minimal footings and no vapour barrier at all, sometimes with a soil floor that has never been covered. Newer homes are typically built on engineered pads with better drainage, but crawlspaces still appear under additions and mechanical spaces, and they are frequently left unheated and under-insulated. In both populations, the damage pattern we document is moisture-driven: mould on joists, rusted hardware, compressed and soaked batt insulation, and softened sheathing in the wettest corners.

Our work starts with determining whether water is arriving as surface runoff, as a rising water table, or both, because the fix differs. Surface water is solved outside with grading and downspout management. A rising table needs interior drainage and a sump with reliable discharge, installed before the space is sealed. Once water has a managed path, we encapsulate with reinforced material, seal around septic and well penetrations, insulate the perimeter walls for our winter design temperatures, and verify with humidity and moisture readings that the space holds its target through a full season.

Calls from Île-des-Chênes concentrate in spring. The ground here is flat, low and clay-dominated, and during melt the water table can sit high for weeks while the subsoil stays effectively impermeable. Homeowners describe water appearing in a crawlspace over several days rather than suddenly, which is the signature of a rising table rather than surface runoff. The other recurring call is about unheated crawlspaces under additions, where frost on the subfloor in winter turns into condensation and mould by midsummer.

Flood management infrastructure shapes properties here, and it is worth understanding what it does and does not do for you. Ring dikes and local drainage works protect against river water; they do not lower the water table under your house. A property can be entirely safe from the river and still have saturated soil pressing against a crawlspace wall for a month every spring. Systems need designing for that reality rather than for the flood maps.

Our first recommendation for most properties here is interior drainage with a sump specified for sustained operation, installed before any sealing, with discharge routed well clear of the foundation and the septic field and detailed so it cannot freeze. Once water has a managed exit, encapsulation and perimeter insulation will hold. Reversing that order is the most common and most expensive mistake made in this area.

Radon is a naturally occurring radioactive gas produced by the decay of uranium in soil and rock. It is colourless and odourless, it moves upward through soil, and it enters buildings through any opening in contact with the ground. Health Canada identifies it as the second leading cause of lung cancer after smoking, and sets a guideline of 200 becquerels per cubic metre for indoor air, recommending remedial action above that level. Manitoba consistently records some of the highest residential readings in Canada, which makes this a local issue rather than an abstract one.

A crawlspace is the most efficient radon entry point a house can have. Where there is exposed soil, or a thin unsealed membrane, soil gas moves into the space essentially unimpeded — and from there into the living area, because the stack effect pulls air upward through a house continuously during the heating season. Our long heating season means that pressure difference operates for a large part of the year. A house with a sealed basement slab but an open crawlspace under an addition can still have substantially elevated levels.

Testing has to come before mitigation, and it has to be done correctly. A long-term test of at least three months, ideally during the heating season when windows are closed and the stack effect is strongest, gives a representative result. Short-term tests are useful as a screening indicator but fluctuate too much to base a decision on. We will arrange or guide testing, and we would rather you test first than buy a mitigation system you may not need — though in a crawlspace with exposed soil, sealing the floor is worthwhile on moisture grounds regardless of the radon number.

Where mitigation is needed, the standard approach in a crawlspace is active sub-membrane depressurization. A sealed membrane is installed across the floor and up the walls — the same membrane used for encapsulation, which is why these two projects belong together — and a dedicated fan draws continuously from beneath it through a perforated collection pipe, venting above the roofline. That negative pressure under the membrane captures soil gas before it can enter the space. The system is simple and highly effective, but it depends entirely on how well the membrane is sealed, which is why installation quality matters more than equipment selection.

Post-mitigation verification is not optional in our view. After the system is running and the building has returned to normal operating conditions, the space and the living area should be retested to confirm the reduction. We also label the system, explain what the manometer reading means, and tell you what to check — because a mitigation fan is a mechanical device that will eventually fail, usually silently. A system nobody monitors is a system that may have stopped protecting you years ago.

Pressure and building dynamics explain why two apparently identical houses can test very differently, and why your neighbour's result tells you nothing about yours. Radon entry depends on the pressure difference between the soil and the building interior, and that depends on stack effect strength, exhaust appliances, mechanical ventilation balance, wind, and how tight the building is. A house with powerful kitchen and bathroom exhaust and no make-up air runs at a greater negative pressure, and draws correspondingly more soil gas. This is also why sealing work and mechanical changes can shift a reading in either direction, and why testing after any significant envelope work is sensible.

System design details separate a mitigation that works from one that merely hums. The collection point beneath the membrane needs a permeable layer — clean gravel or a drainage mat — so the fan can draw from the whole footprint rather than a single spot. The fan has to be sized to the soil's permeability and the area served: too little suction leaves parts of the footprint uncaptured, too much wastes energy and can pull conditioned air if the membrane has gaps. The exhaust must terminate above the roofline and away from windows and air intakes. And the pipe needs a manometer, so the system reports its own status.

Timing relative to encapsulation is the practical advice we give most often. If you are sealing a crawlspace for moisture reasons and you have not tested for radon, test first. The collection pipe and gravel layer belong under the membrane, installed before it goes down; retrofitting them means cutting open a barrier you just paid for and compromising its continuity. A long-term test takes three months, which is usually compatible with planning a project anyway. If the number comes back low, you have lost nothing but gained a documented baseline. If it comes back high, you have saved yourself from doing the job twice.